Below are instructions
to safely attach and remove vintage pins from TJB Inspired pant
cuffs and handbags. Follow these instructions and you'll easily
create new and unique styles with your TJB Inspired products.
You may also view the
following photos for details on how to use your new product:
PANT
CUFFS
ATTACHING:
It is recommended to attach your cuffs to your
pants, shorts or capri’s prior to putting them on. First,
decide which side of the cuff you want to be showing or you may
choose to partially fold down one side and expose both sides at
the same time. You are going to start by finding the center section
of your cuff and matching it up to the inside seam of the article
of clothing for which you are attaching it to. I recommend the
pin entry to be approximately 1” down from the top.
(Remember to stay away from the seams
on your pants when pushing the pins through as it can be too thick
and may cause damage to the pins).
Gently push your pin through each
set of materials onelayer at a time until it is completely through
to the other side. Once the pin is through, push the rubber backing
securely onto the end of the pin. Next, making sure your ‘Cuff
‘is lined up and centered, move to the front section or
back section to apply
your next pins. (Try and space evenly around the cuff). When you
get to the outside of your leg, this is were the last pins will
go. Make sure the excess flap material is facing toward the back
and then apply your pin, (again remember to stay away from the
seams). Just a reminder that you can choose to wear the Decorative
Pins alone on your folded up pant cuff without using the fabric
strip (cuff).
REMOVING:
When you are ready to remove or change your ‘Cuffs’,
hold onto the rubber backing and gently twist and pull
on the pin and backing at the same time. Use the bag that your
pins came in to store them. A couple of extra backings have been
added for your convenience. Use your Vintage Hanger to hang your
cuffs on when not in use (NOTE: I also like to use the hanger
as a photo hanger).
HANDBAGS
ATTACHING: The top
1 ½” of the handbag is the only place where you will
be attaching and placing the pins for holding the fabric on. This
area is the only section designed specifically for the pins. When
attaching the ‘full cover fabric’ you will need (6)
six pins. Start by sliding the handbag into the full cover and
pulling up to adjust for a snug fit. Start on the outer sides
with one pin on either side of the belt loop (remember to keep
pins away from seams) and push through and attach rubber backing,
go to other side and do the same. Next, use your third pin on
either front side and attach to the right of the belt loop, and
then move over to the left of the other belt loop and attach the
fourth pin. Do the same on the other side and attach your fifth
and sixth pins.
When attaching the 4” strap
you will use one pin. When attaching the pins to the ‘Handbag’
gently push the pin backing through the ‘Collection Fabric’
first and then gently through the handbag fabric and attach snuggly
with the rubber backing. It is recommended to periodically check
your backing and make sure they are snug.
REMOVING: To remove
the backing, gently hold on to the front of the pin and the back
of the pin at the same time and gently twist and pull apart at
the same time. It is a snug fit.
How to Measure
Cuff Size | Product Care | Product
Availability
Home |
About TJB | About our Products
| View Cart | How
to Use Pins
Contact Us | Request Info | Policies
Admin
Login
